How thick can a 100W CO2 laser cut?

The 100W laser tube can cut plywood as thick as 20mm and create high-resolution engravings with up to 4500 dpi.

How long does CO2 laser tube last?

All glass CO2 laser tubes degrade over time with lifespans ranging from as little as 3 months to 3 years. Basically, the CO2 inside the tube breaks down into Carbon Monoxide and Oxygen with use. If you overdrive the tube, it just accelerates this process and reduces the working life.

What is the spot size on a CO2 laser?

The wavelength of CO2 laser is 10 micron (0.01 mm), therefore this is the smallest diameter of the circle it can be focused to.

How do you align a CO2 laser?

Never bypass the machine’s safety features or operate the laser with the lid or access panels open.

1. Step 1: Optimize Your Pulse Setting.
2. Step 2: CO₂ Laser Tube Alignment: How to Align the Laser Tube.
3. Step 3: Align the First Laser Mirror.
4. Step 4: Align the Second Laser Mirror.
5. Step 5: Laser Alignment: The Third Laser Mirror.

Can a 60 watt CO2 laser cut metal?

Since this laser is a C02 laser, it will not cut ANY metal. You’d need a fiber laser for that, however it will mark on metal using thermal marking spray. It will cut cork, soft and hard wood, acrylic, cardboard, and paper. It will mark on glass, slate, stone, granite, and marble.

Is diode or CO2 laser better?

In general, it is quite obvious that if you have little working space and do not need to cut something 24/7, do not need to cut very thick materials (10 mm or more of plywood or wood), then a diode laser is the best option. Most people prefer diode lasers over Co2 machines because of their smaller sizes.

Can laser tubes be recharged?

SSI / PLC / LEI laser tubes have a Copper ‘fill tube’ that is pinched off each time the laser tube is refilled. After you have refilled these tubes twice, this fill tube becomes too short and a complete new ‘fill tube / mirror mount’ must be put on the laser tube by the glass shop.

How do you align a mirror with co2 laser?

Drive the laser head to the front of the machine and put a second dot on the target tape. The two dots should be in the same position when the machine is aligned. The mirror can be adjusted from the front of the machine but if you are uncertain it is easier to be standing behind the machine looking forward.