How do I identify my Eaton axle?

Axle Housings are identified by the specification number stamped on the rear right-hand side of the axle housing. This number identifies all components of the axle as built by Eaton, including OEM special requirements such as yoke or flange. Some axles may also include an identification tag as shown.

How much oil does a Eaton rear end hold?

The owner’s manual says it takes up to 15 quarts.

What axle do I have?

Stamped Number on the Axle To figure out exactly what axle you have, you can look for the Dana stamped bill of materials number. This stamped number can usually be found on the righthand side or on the longer axletube on the same side of the tube as the differential cover, facing the rear of the truck.

What axle is in my truck?

What does 2 speed rear end mean?

A two-speed rear axle allows the driver to select a low range for greater pulling power and a high range for greater road speed and fuel economy. You can also use these ranges to provide extra steps between transmission shifts when driving on steep grades or fuel economy may be factors.

What is a 2 speed transmission?

The transmission has two forward gears and one reverse gear, a neutral position, and the possibility of semi-automatic gear shifting. The neutral allows to safely tow the vehicle in the event of an electric motor failure, which was a specific requirement of the customer.

What is a 2 speed rear?

Are 2 speed rear ends good?

The advantage of a 2 speed or quick change rear end is that when you are towing you could pick a rear ratio that gives you 6 useable towing gears instead of 4-5. It would also give you more available power at most road speeds.

How do I identify my GM differential?

Information about Differentials in GM vehicles can usually be obtained by looking at the RPO or “Regular Production Option” codes contained in the Service Parts Identification tag in the glovebox. Whenever possible, reference the tag numbers when ordering parts for your Differential.

How does a 2 speed RC transmission work?

the one way bearing is mounted on so that the rotation of the motor locks the bearing so the first gear can drive the transmission. Once a certain rpm is reached, the springs holding the clutch shoes expand enough that they grip the clutch bell, and the second gear now will start to drive the transmission.

Why is the Powerglide so good?

A Powerglide transmission is very durable in stock form — start adding some aftermarket parts and you have one stout unit. This elevated level of durability is another reason a Powerglide is perfect for bracket racing, as they can take a beating for an extended amount of runs.

What type of axle do I have?

How do I find the axle ratio on my GMC Sierra?

To find the axle gear ratio of any GM vehicle, locate the RPO sticker (typically located in the glove box) and write down any codes starting with F, G, or H.

What kind of axle do I have?

How much bend should a trailer axle have?

view full answer… Should Trailer Axle Have Slight Upward Bend You did not specify which way your axle was bent, but a trailer axle such as the Dexter Trailer Axle Beam #T3584F-EZ-8974 should have a slight upward bend, as you should be able to see in the accompanying photo of this axle installed.

How do I know what GM rear end I have?

Identify your GMC or Chevrolet rear end gear ratio by the RPO Codes, usually located on the placard labeled “Service Parts Identification” inside the drivers door panel or glove box.

What are the parts of differential assembly?

Differential Parts

• Bearing kits.
• Individual seals and bearings.
• Ring and pinion sets.
• Axle shafts.
• carrier/pinion shims, pinion nuts, crush sleeves and ring gear bolts.
• posi-traction and internal gear kits.
• housings carriers.
• These are just some of the component parts in stock.