How do I reset my genie 1930?

hold the button and turn the key switch to the ON position. hold the button and turn the key switch to the ON position. (O TO 10 SECONDS, 2 IS THE DEFAULT.

How long does it take a Genie GS 1930 to charge?

In some instances, it can take about six hours to charge a lift before an operator can use it for a full work day. Comparatively, Genie lifts and other types of electric aerial work platforms (AWPs) can take approximately 12 to 16 hours to charge.

What is the weight of a Genie GS 1930?

The Genie® GS™-1930 slab scissor lifts are easy to manoeuvre in tight spaces, boast quiet electric operation and are ideal for indoor and outdoor applications on firm, level surfaces….Overview.

Specification	Value
Platform Capacity	500 lb | 227 kg
Machine Width and Length	2 ft 6 in | 0.76 m
Weight	6 ft | 1.83 m

Why is genie lift beeping?

Once the outriggers pads are in contact with the ground, the green LED lights on the outrigger push-button will light. The TZ will then lift up at the back end until the tires are slightly off the ground, at this point the module will beep.

How do I make my genie lift go up?

Raising/Lowering Your Genie Scissor Lift Depress the trigger mechanism on the handle (3) Push the joystick forward to raise the lift and pull it down to lower it (3) If you would like to use the horn or change the speed of the lift, you can use the corresponding buttons (2)

What does Ch mean on a scissor lift?

CH NOT A FAULT CODE All Models Indicates that key switch is in base controls.

Where is the serial number on a Genie GS 1930?

The serial plate is located on the control box side above the swing motor.

How tall is a 1930 scissor lift?

Genie GS-1930 Electric Scissor Lift For Rent The Genie GS-1930 has a platform height of 19 feet, 500 pound capacity, is 30 inches wide and about 6 feet long. The overall width is narrow enough to fit through a doorway or in tight areas.

How do you test a scissor lift charger?

If you don’t notice any damage, plug the charger into the extension cord, then plug the cord into an outlet. The lights on the charger should illuminate to signal that the batteries are pulling power from the outlet. Leave the equipment to charge overnight so you can be sure the batteries get a full charge.

How do you move a Genie scissor lift manually?

Maneuvering Your Genie Scissor Lift Ensure that the machine is set to driving mode (4) Depress handle on the joystick (3) Use the buttons on the top of the joystick to move the wheels left or right (3) Push the joystick forwards or backward to move the lift in your desired direction (3)

How long do genie lift batteries last?

Unfortunately, the lifespan of a scissor lift battery is consistent. In fact, battery suppliers often estimate that a scissor lift battery could last between 6 and 48 months.