How do I enable LAN 2 on DrayTek?

How do I enable LAN 2 on DrayTek?

At the page of LAN >> General Setup, check the “Enable” box of LAN2 and LAN3. Then click OK to save the configuration and reboot the router. 3. You can edit the detailed IP and DHCP settings by entering Details Page.

How do I setup a firewall on my router?

Enable and Configure Your Router’s Built-In Firewall

  1. Access your router’s configuration page.
  2. Locate an entry labeled Firewall, SPI Firewall, or something similar.
  3. Select Enable.
  4. Select Save and then Apply.
  5. After you select Apply, your router will likely state that it is going to reboot to apply the settings.

How does DrayTek firewall work?

The filter rule first checks if the header information meets the filtering condition in that rule, including direction, source IP, destination IP, and service type. If it does, the action selected in Filter Action will be applied. If it doesn’t, it will take no action and pass the packet to the next active filter rule.

What is IP Pool count?

An IP pool is a sequential range of IP addresses within a certain network. You can have multiple pool configurations. Each pool can have a priority and can be assigned to a group. IP addresses can be assigned dynamically from a single pool or from a group of pools.

How often should you replace your firewall?

every 3 to 5 years
We recommend replacing your firewall every 3 to 5 years. As mentioned above, your firewall should be updated as often as security updates and patches are released for it. Just like computer operating systems, firewalls reach an end of life date. After that date no more security patches and updates are released.

What is LAN pool and WAN pool?

LAN IP address is the address given to your host within your local area network, while your WAN IP would be the address given to your routers interface that is connected to the internet, usually at your point of demarcation between you and your ISP.

How do IP pools work?

What makes the Draytek Vigor 2930 unique?

The Vigor 2930 is in an all-new DrayTek housing design with all LEDs and sockets provided conveniently on the front. This makes desk usage, wall mouting or rack-mounting (optional bracket required) all equally covenient.

Is there a difference between DrayTek 2850 and Cisco router?

This person is a verified professional. Verify your account to enable IT peers to see that you are a professional. We have some Draytek 2850, all VPN connected, I haven’t noticed any difference in speed between these Draytek routers and Cisco ones… I have done several speed tests and the speed are same as original quoted speed.

How do I fit a vigor 2930 router in a cabinet?

The RM1 Rackmount Bracket enabled you to fit any Vigor2930 series router into a standard 19″ rack or cabinet. The bracket takes up one rack slot (1U). The front mounted sockets remain fully accessible. For wireless models, we then recommend extension aerials (or aerial extensions).

What is the USB port on the vigor 2920 used for?

The 3.5G USB mobile can be a backup broadband connection if the primary fixed line drops. The Vigor2920 series USB port can also be used to add storage memory. You can connect USB disk or hard-drive to the USB port for file sharing.