How do I program my Simon XT key fob?

How do I program my Simon XT key fob?

You can program a key fob to an Interlogix Simon XT by accessing the System Programming Menu. Put the system in its learn mode and then press and hold the top two buttons on the device. Once the key fob has been learned in, you can adjust its settings and configurations as needed.

How do I reset the code on my GE Simon XT?

You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.

What is the default installer code for a Simon XT panel?

Installer code Depending on how the access code is set, the default installer code is 654321, 54321, 4321 (factory default), or 321.

How do I clear Simon XT status?

Clearing Status: To clear system status, press the STATUS button, read and/or listen to the status messages, then press DISARM. If the trouble condition was a low system battery, perform a sensor test. The STATUS light should turn off if all trouble conditions have been corrected.

How do I change the battery in my Simon XT?

Simon XT – Replacing Panel Battery

  1. Go to your keypad and press down on the two tabs on the top of the keypad.
  2. Cover will swing down revealing battery inside.
  3. Take new battery and replace leads pairing black with black and red with red.
  4. Place batter back into the panel, leads down.

How do you silence trouble beeping on Simon XT?

Simon XTi – Silencing Trouble Beeps

  1. Press GEAR icon at the bottom right then press DOWN ARROW 3 times.
  2. Press ENTER by Programming then enter the Master Code, then press OK.
  3. Press SIREN OPTIONS then UNCHECK Trouble Beeps then press CLOSE to exit.
  4. Press CLOSE again to exit programming.

How do you remove a zone from an alarm system?

To do so, follow these steps:

  1. Enter zone programming. From the home screen, press Security > More (Lynx Touch Only) > Tools > Enter Installer Code (default is 4112) > Program > Zones.
  2. Delete the zone. From the zone screen, highlight the zone you wish to remove.
  3. Exit Programming.

How do you reset the low battery on a Simon XT?

What type of battery does a ITI Simon XT use?

The GE Security Simon XT alarm battery set includes 1 battery – SP6-1.2 (6 V 1.4 AH).