How long do you let a new PUR filter run?

USING YOUR FILTER When you use your filter for the first time ONLY, run cold water for five minutes. After that, your filter is ready for use whenever you turn on your faucet.

How long do you soak PUR water filter?

Soak it in cold water for 15 minutes. Only use cold water. Using warm or hot water may harm the filter cartridge. After 15 minutes, remove filter cartridge (B) from water and rinse under cold water for 10 seconds.

How much water should you run through a new PUR filter?

Run cold water through the filtration system for 5 minutes. PUR faucet filters work for 100 gallons (380 L) of water, or about 3 months of use. Don’t run water over 100 °F (38 °C) through the filter since you could damage it.

Do you need to run water after changing filter?

Through shipping and handling, bits and pieces of the carbon block may become loose inside your filter. Although drinking it won’t hurt you, most people prefer to run water through the filter because of the bitter taste carbon can leave in your mouth. Flushing your newly installed refrigerator water filter is easy!

Do you have to soak PUR faucet filter?

Question: Should I soak the filter before use? Answer: PUR PLUS Pitcher with Lead Reduction Filters: Yes, they need to be soaked in cold water for 15 minutes and then held under cold running water for 10 seconds.

Can you drink water right after changing filter?

With a properly installed water filter, your water runs through this block to filter out any contaminants and particles picked up before entering your refrigerator. By doing so, water is safe for drinking and tastes clean.

How do I know if my PUR water filter is working?

The light on your pitcher should come on each time you use it with a green, yellow, or red color to indicate the appropriate stage in the filters lifespan. To manually check if it’s working, simply hold the reset button for 3-5 seconds (faucet = 3; pitcher/dispenser = 5), and then release.

What happens if you don’t flush a water filter?

Weird Taste or Smell If you drink your water without flushing it you might notice a funny taste or smell right away. This is most likely a result of the same two causes above. If there’s a high amount of carbon bits, that could definitely affect the taste.

How do you reset the PUR filter indicator?

PUR Faucet Filters

1. Remove filter and place back into unit.
2. Push the reset button in for 3 seconds until all 3 lights flash, then release.
3. Make sure reset button is not stuck in. If reset button is stuck, pull up on button so it springs back into place.

Why is my PUR filter not working?

PUR filters may be slow because of air blockages, high sediment levels, hot water or mineral damage, incorrect installation or an old filter. The PUR MineralClear® filter may also result in longer filtration times than the basic filter because of greater contaminant reduction.

Can you get sick from water filter?

Yes, your old filter can add bacteria to your water This can make you sick if you continue to use the old filter. An older German study found that the amount of bacteria was less in tap water than filtered water after one week of use at two different temperatures.

What does the red light on a PUR filter mean?

Answer: To ensure maximum contaminant reduction, replace your PUR filter after 100 gallons of use or every 3 months. * If your Filter Change Light flashes red, it’s time for a new filter. Question: What do I do if I notice my faucet system is filtering slowly?