What is error F09?

What is error F09?

The F09 error is a water pump problem, either clogged pump, or pump malfunctioning, Check for something clogging the water pump.

Why does my washer keep saying E1 F9?

If F9 E1 (drain pump system problem – long drain) appears in display, the washer is taking too long to drain water. The drain may extend more than 4.5″ (114 mm) into standpipe. Check plumbing for correct drain hose installation.

What does E9 mean on washing machine?

Cause: E9 is a prompt alarm, which only appears during the operation of program “Wash and Dry”. E9 indicates that the load exceeds the rated capacity or clothes are close to the inner cylinder wall before drying.

What does F09 mean on a washing machine?

LONG DRAIN TIME
Whirlpool Duet Washer Error Code E01 F09 means LONG DRAIN TIME. When your Whirlpool washer goes into drain mode and the drain time is past 8 minutes and not reaching the reset level in the pressure sensor then the valves in the drain are turned off and the drain pump will cease to pump out the water.

How do I fix the error code E01 F09 on my Whirlpool Duet washer?

1 – You may have a drain hose that is bent and not letting the water drain out – Check the back of the washer. 2 – Be certain the drain hose height does not exceed 96″ or the washer cannot drain properly. 3 – Clean the drain pump filter on the bottom front of the washer of any particles or objects.

How do I fix E1 F9 on my Whirlpool washer?

How to Fix Whirlpool Washer E1/F9 Error Codes

  1. Try a Reset. Sometimes an error code is caused by a control board glitch, where resetting the washer is all it takes to resolve the error code.
  2. Check your Detergent.
  3. Check the Drain Hose.
  4. Clean the Filter.
  5. Check the Drain Pump.
  6. Check the Wiring.

How do I fix the error code e01 f09 on my Whirlpool Duet washer?

How do I force my washing machine to drain?

How to drain a washer filled with water

  1. Try the spin cycle.
  2. Turn off the power and water supply.
  3. Remove and check the drain hose.
  4. Check to see if it will drain with the help of gravity.
  5. Check your machine’s inner workings.
  6. Check the drain pipe.
  7. Drain manually if needed.
  8. Call a service professional.

How do I drain my Whirlpool washer full of water?

  1. Step 1 – Turn off the power.
  2. Step 2 – Locate the drain hose at the back of the washer.
  3. Step 3 – Prepare your bucket and drain hose.
  4. Step 4 – Check for and remove all clogs in the drain hose.
  5. Step 5 – Check for deeper clogs in the drain or beyond.
  6. Step 6 – Inspect the washer pump.