What is Xylene in australia?

Diggers Xylene is a specialty, solvent-based acrylic sealant thinner used for thinning and stripping sealers.

What is Xylene Thinners?

Xylene Thinners is a strong general purpose solvent. For thinning and cleaning equipment when using most quick drying paints.

How do you use digger xylene?

Always follow the manufacturer’s directions when thinning sealers. Test a small area first before taking on the whole job. Saturate a lint free cloth and wipe the surface using a clean part of the cloth for each wipe. Do NOT use on painted surfaces or Perspex.

Is mineral spirits same as xylene?

The mineral spirits left after the toluene and xylene are removed is sold as “odorless” mineral spirits….Understanding Solvents: Part I.

Solvent	Dissolves	Thins
Toluene (toluol) Xylene (xylol)	Wax Water-based finish	Wax OilThe Finishing Store News Varnish (incl. polyurethane varnish) Conversion varnish
Alcohol (denatured)	Shellac	Shellac Lacquer

How do you apply xylene to concrete?

The best way to apply xylene is by flooding it onto the surface with an industrial metal pump-up sprayer. If enough is applied, the xylene should melt the sealer through to the surface of the concrete before it evaporates. In conclusion, applying xylene is a great, inexpensive way to rejuvenate dull or whitened sealer.

What chemical is similar to xylene?

Substitutes for Xylene Explained

• Paraffinic and isoparaffinic hydrocarbons (i.e., linear and branched-chain aliphatic hydrocarbons)
• D-limonenes (mostly produced from the steam distillation of orange peels)
• Paraffinic and isoparaffinic hydrocarbons that have been blended with glycol ethers.

Does xylene clean concrete?

Xylene will work good for removing solvent based concrete sealers. It’s a little messy, but Xylene will re-emulsify the concrete sealer and soften it to the point where you an pressure wash it off. You can pour or spray on the Xylene in a small section, don’t let the xylene evaporate.

What does xylene do to concrete?

The Xylene will quickly open the sealer up and allow the moisture to escape, causing the sealer to dry a clear color. You likely won’t need to apply any more sealer to areas that are just sprayed.

How do you apply xylene to a concrete patio?

Apply the Xylene in sections. Pour the Xylene on the surface and allow it to sit for about 45 seconds. Then, pour on a little more and use a stiff straw scrub brush to lightly scrub and break up the sealer. The Xylene will melt the sealer back into it’s liquid form.

Does xylene hurt concrete?

Keep in mind, if your concrete was stained or dyed using Xylene, it can damage or change the color of the concrete. If you want to add a new solvent-based sealant, you can just apply the new solvent directly unto the concrete without having to go through removing the old sealer.

Do you mix xylene with water?

Xylene does not mix well with water; however, it does mix with alcohol and many other chemicals. Most people begin to smell xylene in air at 0.08– 3.7 parts of xylene per million parts of air (ppm) and in water at 0.53–1.1 ppm.

What can be used in place of xylene?

Carrot oil, Olive oil, Pine oil, Rose oil, are not only bio friendly and economical but can also be used as clearing agent instead of xylene.