Where does the threshold go in a doorway?

To get the most accurate positioning, your threshold bar should lie directly below the door, so that you can’t see the strip when the door is closed.

How much space do you leave for a threshold?

The standard width of threshold molding pieces is 2 1/8 inches. You should leave a gap of 3/8 inch between the outer edge of the threshold molding and the track for the sliding door and from the edge that faces the inside of the room.

Where do door thresholds go?

How do you place a threshold?

To install a wood threshold onto wood or carpeted floors:

1. Pre-drill pilot holes into the threshold.
2. Position the threshold underneath the doorstops.
3. Nail the threshold to the floor with collated flooring nails.
4. Alternatively, countersink the threshold and fasten it with countersunk wood screws.

Do you need transition strips between rooms with laminate flooring?

Transitions are installed only if there are doors in between the rooms. Besides separation two different floor types, these strips are also useful for rooms that are not in the same level. When installing laminate flooring, it can be set without the transitions.

What is the best glue for transition strips?

Johnsonite 996 Two Part Epoxy Glue
Johnsonite 996 Two Part Epoxy Glue is a recommended adhesive when installing wheeled traffic transition strips. The Johnsonite 996 adhesive comes with 2 containers for a combined .

What adhesive should I use for threshold?

I’d say a bit of Liquid Nails (use whatever type is spec’ed for wood) and some brads would be your best bet. I would use Gorilla Glue, as polyurethane glues are waterproof in a way that polyvinyl acetate glues aren’t.

Can you glue down a threshold?

If the subfloor is concrete, you may need to glue the threshold down. To do this apply a strong adhesive to the edge of the wood flooring, and then place the threshold over the gap between the two sections of floor and push down on the piece to glue down.

https://www.youtube.com/watch?v=3On5inT8GdA