Why is my Interpet filter not working?

When a filter stops working it usually is related to a blocked impellor. Turn your filter off at the power and check the impellor for blockages. If the impellor is over 12 months old, or showing signs of wear, it needs replacing. Also, check and clean the filter cartridges.

Why is my filter not pulling water?

The most likely cause is that the air pipes of the filter are disconnected or blocked or the air pump has broken down (See Q1). Once the pipes are cleared or reconnected or the pump has been repaired or replaced – the filter will work again and the tank will clear.

Why is my aquarium water filter not working?

The most common issue when there is no suction in the filter is that there is a clog somewhere along the line. If you can hear the filter motor running, but you can see no visible suction, then chances are that you have got yourself a clogged intake tube, impeller, or outtake tube.

Why is my fish tank filter not blowing bubbles?

If your filter’s impeller is beyond repair, you will have to replace it with a new one. However, most often than not, the impeller is simply clogged and you can easily clear it with a tiny brush. It is normal for aquarium filters to form some bubbles.

How do I know if my aquarium filter is bad?

How to Know if My Internal Aquarium Filter Is Broken

1. Water Stops Moving Through the Filter. If the motor is humming but no water is moving, the motor works but the filter itself has shut down.
2. Filter Rattles When Turned On.
3. Dirty Parts Inside the Filter.
4. A Crack in the Facade.
5. Suction Cups Missing.
6. A Word About Cleaning.

Do I need to prime fish tank filter?

For water filtration pumps, you will need to prime the system to get the water moving. Very few aquarium filter pumps are self-priming. To prime means to place water in the portions of the filter that should be filled with water during normal operation before you turn on the motor.

How do you unblock air stone?

Soak the airstone in a solution of one part household bleach to three parts fresh water (1:3) for 24 hours. Bleach has the advantage of both cleaning the stone and also disinfecting it. Soak the stone for a full 24 hours, or two days if the stone was badly clogged.