Why is my Maytag washer lid lock blinking?

The Lid Lock Light will flash if Lid Lock has not moved into the Lock Position, the Lock Motor can not be powered, or the Lid is not closed completely due to interference. Some models will lock immediately, while others will not lock until after the wash cycle has started.

How do you reset the lid lock on a Maytag washer?

Touch “Cycle Signal” near the front-loading washer’s LCD control panel to deactivate the washer’s lock controls. The lock icon disappears from the LCD control panel when the lock control is off.

How do you reset the sensor on a Maytag Centennial washing machine?

How to reset Maytag Centennial washer (step by step) Simply unplug your washer for about 15-20 seconds then plug the machine back in. You can also reset the breakers again for anything between 20 seconds to 1 minute.

Do Maytag washers have a reset button?

Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.

Why is my Maytag washer not locking?

Common solutions for: Maytag Washer door or lid won’t lock If the door lock is defective, the washer door will not latch properly. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.

How do I fix the sensor on my Maytag Centennial washer?

Alternative “reset” method

1. Turn off water supply to the washer.
2. Then unplug it from power supply.
3. Wait a minute.
4. Reopen the water supply.
5. Plug it back in.
6. Go ahead and hold down the power button for about 10 or more seconds.

Can you bypass washing machine door lock?

One of the main ways of bypassing a washing machine door lock is by disabling the safety circuit. It is good to note that the process involves cutting of electrical wires. Thus, you need to disconnect your machine from the main power supply. Additional, cutting the cord may void your warranty.